TICK OVER

· 9 · 4523

0 Members and 1 Guest are viewing this topic.

*

kvz2000

  • *****
  • Posts: 435
  • Name: Donald
TICK OVER
« on: May 20, 2010, 08:31:28 PM »
Hi All,

I have a 1993 4.2 petrol V8 Rangerover, starts and runs great, its only covered 90k miles and has Full Service History with the last service only a couple of thousand miles ago.  It has started on occassions to rev up and down when ticking over which can sometimes cause it to cut out, its an Auto so a nuisance when it does this. Doesnt do it all the time and usually after being driven for about an hour. I know this is a problem with many models of cars but wondered if someone could guide to what things I should check......

Ta

Donald.

*

plenty ponies

  • *
  • Posts: 15
Re: TICK OVER
« Reply #1 on: May 20, 2010, 09:54:09 PM »
hi there,
1st check from the plugs back,otherwise try this,,,,,,,

i,m not sure if this will help,but have a look thrue the workshop manual for something like a P.T.U.,,,,why do i suggest this,
well my 300zx cut out when it was warm,otherwise runs fast and true,,until it warmed up a little,it was my ptu(power transistor unit),cuts the engine out,,,,now on the 300zx it has seperate coil packs,this is what a ptu does,send the correct pulse and amount of currant/voltage to each coil at a presice time of fire,vroom,,,
i hope this has helped or maybe it's made it worse.
good luck
1995 "itsashitty" shogun 2.8 td lwb
1985 porsche 944 sorn
1998 bmw e38 740i sport 4.4
1990 300zx j spec sorn

*

rangerovering

  • *******
  • Posts: 1272
Re: TICK OVER
« Reply #2 on: May 21, 2010, 03:07:43 AM »
The base idle could be at fault. I am not clued up enough on the EFI's to know what to do but I can put you in touch with a man who can talk you through it ;)

Steve




*

kvz2000

  • *****
  • Posts: 435
  • Name: Donald
Re: TICK OVER
« Reply #3 on: May 21, 2010, 07:19:20 AM »
Hi Steve ,

That would be great thanks, would like to have a go at
fixing before taking to the garage but no idea where to
start.

*

mac

  • *****
  • Posts: 171
Re: TICK OVER
« Reply #4 on: May 21, 2010, 09:42:46 AM »
Air bypass stepper motor?  Left hand side of the plenum (the silver bit on the top with 4.2 written on it!) there should be a 4/5 pin connector block.  Try disconnecting that and see if it's any better/worse.

Has your fuel consumption gone up?  If so it could also be a faulty Air Flow meter.

it was my ptu(power transistor unit),cuts the engine out,,,,

The 4.2 has a distributor not coil packs.

*

Buffalo Bill

  • *****
  • Posts: 1493
  • Name: Bill Conner
Re: TICK OVER
« Reply #5 on: May 21, 2010, 11:25:17 AM »
Have you checked all the hoses etc to make sure you dont have an induction leak??
1989 110
1990 90
1988 90
1972 V8 WOOP WOOP

*

rangerovering

  • *******
  • Posts: 1272
Re: TICK OVER
« Reply #6 on: May 21, 2010, 11:40:03 AM »
PM sent ;)
Steve




*

wesley

  • ***
  • Posts: 146
Re: TICK OVER
« Reply #7 on: May 22, 2010, 11:50:31 PM »
Hi ive seen a v8 with a partial melted coil... It ran fine but cut out at tick over (time varied) The voltage had dropped. Check all leads for blue spark to earth. How clean is your air filter?? These are simple things to check Good luck

*

kvz2000

  • *****
  • Posts: 435
  • Name: Donald
Re: TICK OVER
« Reply #8 on: May 23, 2010, 01:14:24 AM »
Thanks Guys ,

I will try some of the suggestions, it's intermittent so don't
think it will be air leak from hose

DN