Register



Pages: [1]

Fitting Mill Services Rockslider to Series

· 4 · 1467
« previous next »

0 Members and 1 Guest are viewing this topic.

*

Petes_Series

  • ***
  • Posts: 111
Fitting Mill Services Rockslider to Series
« on: December 30, 2016, 11:00:27 AM »
Has anyone bought and fitted one of these. If so can they send me pictures of the setup?

The fitting instructions supplied are a bit vague anf it would help to see what someone else has done before I go drilling holes.

Cheers,

Pete.
Logged
We all know that small cars are good for us. But so is cod liver oil. And jogging.
*

rangerovering

  • *******
  • Posts: 1272
Re: Fitting Mill Services Rockslider to Series
« Reply #1 on: January 12, 2017, 12:51:16 PM »
I had a set on my 88", since sold the vehicle but can describe if it helps.

From memory I just bolted the front to the bulkhead then cut the supplied flat bar with suitable angles to fit it to the front tub cross member. It wasn't a particularly precise job but with the inacuracies of different landys its not really any surprise.
 
I cant even remember if mine came with instructions!
Logged
Steve



*

Petes_Series

  • ***
  • Posts: 111
Re: Fitting Mill Services Rockslider to Series
« Reply #2 on: January 13, 2017, 10:54:48 AM »
So the front tub outrigger is an upside down J

Is it the outside of the upright of the J. The inside of the J. Our somewhere else?
Logged
We all know that small cars are good for us. But so is cod liver oil. And jogging.
*

rangerovering

  • *******
  • Posts: 1272
Re: Fitting Mill Services Rockslider to Series
« Reply #3 on: January 16, 2017, 09:38:00 AM »
On the outside of the J from your description I believe.

Can you take some photos and show what you have to work with? Just incase the design has changed
Logged
Steve



Pages: [1]
« previous next »