Hello,
Over the past few years I've had a number of injector pipe failures.
The first was a result of the air filter housing bashing against one, fixed that, but over the past four months the number 4 pipe has fractured about half an inch out from the pump on three occasions. When fitting new pipes I've noticed that none of them have wanted to line up properly, whether I try fitting top or bottom end first.
I've needed to slightly bend the pipe to make it sit square onto the pump end thread. Then the other day the number two sheared in the same place.
I can see that vibrations could make them fail but the number 4 has gone four times now whilst I've had the Landy. And like I said, it puzzles me that new pipes don't quite line up.
Any thoughts appreciated.
Mike.