SLROC Forum

whats the best method to bleed discovery 1 clutch? (total empty new system)

thanks

dave

Eazybleed kit!!!

(use a car tyre, at no more than 20psi)

Haha Glad to see you have the same problem as me Dave...

Whats a Eazybleed kit? 

get yourself a bit of soft rubber pipe that fits tight over the bleed nipple cut pipe about 12 inches long block one end of the pipe with a bolt then with a very sharp blade make a small slit in the pipe near the end of the bolt then a small plastic bottle drill a hole in the lid and pull the pipe thru the lid keeping the bolt in the bottle put the other end on the bleed nipple and slacken nipple and pump peddal till no air coming out tighten nipple job done

hope you understand this 

Thanks chaps, I kept on pumping the pedal and fluid started to flow in the end, I have got a eazy bleed kit in the garage somewhere, need to try and dig it out

cheers

dave

For future use....

Fill up reservoir
Clear tube and bottle on the bleed nipple with spanner
Pump the pedal 8 or 10 times and hold down
open and close the bleed nipple
pump another 6 times and hold down
repeat the last 2 steps until fluid comes through/air is out.

Remember to keep the fluid level topped up!

Cheers for info

dave