Hi guys,
just fitted a new heater marix to my Landrover ( 200 TDI ) whilst I was waiting on the part I had just connected to two pipes going to the heater and ran the vehicle without any problems , today I fitted the new matrix, started up the engine and all seems fine.
The expansion tank level hardly dropped much and as the matrix had no water in it I thought that when started the water level would drop as the matrix filled ?? Ran the engine for about 30 mins , pipes to and from matrix heat up and the heater is working fine, I just thought that after doing this job I would have to spend some time getting the air out of the system?
Took the landrover for a quick run and again all seems fine , I do have a problem as my temp gauge always read very high as I've never been able to get a temp sender that reads properly from 200tdi to 90 gauge .
So how would I know for certain that I have to air locks?
Cheers
Donald.