Lookin for a bit of advice.
I was down at Shugs today to get an inspection of the chassis as it requires some welding. The worst part is the cross member below, it's seems pretty solid in the middle but each end where it attaches the rest of the chassis needs attention.
Having look at Bill's its nowhere near as bad or DaveT's (thanks for the use of the photo Bill) but needs fixed before MOT!
What's the best way to go, weld it up or try and source the section and weld it in? Shug says both are possibilities but I think sourcing a section in good condition would be difficult unless anyone could help me out?
Any advice or help would be much appreciated?
Thanks Chaps.
![](http://i925.photobucket.com/albums/ad96/StephenOR/5e6c489ce75321504d553e46f6543c45_zpsbc390916.jpg)