Hi all,
I attempted to bleed my freshly installed clutch hydraulics the other day, and couldn't get a good seal with the eezibleed on the top of the master cylinder. This appears to be due to the sealing surface on the master not being machined very well, a 1/2" section of the sealing surface is quite rough.
After giving up on the eezibleed and bleeding it the old fashioned way I've managed to get the clutch working enough to drive it, but it feels like the clutch isn't fully disengaging. Could this be because there isn't a good seal between the filler cap and the reservoir? If so are there any quick fixes that I do without having to pull the master out again and replace it? e.g. silicone on the sealing surface?
Thanks,
Robbie