SLROC Forum

Hi iam trying to get a rover V8 efi serpentine engine running I believe the engine i have is from a soft dash range rover 3.9 efi. I have not managed to come across a wiring diagram for this model with loads of searching.
If any one has one available or knows where to source one that would be great. Or if you have done this before and remeber the wires that need connected that would be great there is 1 brown plug with 5 wires and 1 white plug with 9 wires.
Thanks in advance George   

Hi George,

Do you have a photo and a description of which part of the loom the plugs are attached to? To get 14CUX running there is only 4 wires!

Cheers

Probably not what you are looking for, but loads of info here...

http://www.britishv8.org/articles/rover-14cux-efi.htm

Hi thanks for the replys
I have a white plug with the following wires
Green /blue
Orange/ black
White/ slate
White / brown
White / blue
Red / slate
Brown /yellow
Purple/ yellow
Yellow / pink
These are all thin wires with small pins

Brown plug with following wires
Brown/green
Purple/white heavy cable
Purple /White slightly thinner cable
Brown/red
White / green slightly thinner cable

These two connectors are next to each other closer to the engine loom. I also have 2 30 amp relays plugged in next to the ecu.
Thanks for the replays and I will have a look at the link George