So it's a maintenance version then. Should have hood sticks and a hood as well. Was fitted with pods containing racks for the electronic test gear. I've got one of these pods, but none of the test kit.
The wheels are different from the usual Land Rover/Sankey ones as the centre is deeply offset so tyres don't run on the side of the trailer. Trickey if you want to carry a spare.
Yes maintance and a how to guide is what I'm after, the way it can be lowered and raised, how the hydraulic brake system works and parts, normal handbrake mechisum and parts.
I will be fitting a rear spare tyer to one side of frame plus fitting a hand whinch to rear so I can use it to transport my lawntractor up to my mums and back , the hoop system I will look at and possibly make some up and obtain some cloth also to make one for it good excuse to use my pipe bender again, will Aldo make up some ramps fir it also along with side holders to bolt and lock them on fir use, so in all plans upon plans for it.
As for engine I have near,y fully stripped one down completly and found it four pistons and bearing in very good condition showing very little wear or use as checked bearing against new one I have and damm near spot on same as new!! So plan next it to get other block with the cracked Pistons out and replaced and possible bearing too but won't know till I get in and about it next .
Laters all
John