SLROC Forum
General Category => TECHNICAL CHAT => Topic started by: JOHN ATHERTON on May 11, 2020, 09:04:25 PM
-
Hi
I have converted a series 2a from diesel back to petrol2. 5 l 4cyl petrol. It has a series 3 dash like a 90. It was going well but needed to replace horn arm and decided to wire in a push button as indicater / horm, arm was faulty.
In so doing I shorted it out when cutting into a wire behind dashboard. Lots of sparks!
Horn works well but won't turn starter. It also had a faulty starter switch which I replaced today along with a new starter motor as thought it had welded mechanism.
It is just the same.....
making a slight clicking noise on engaging starter but doesn't turn starter. HELP!
John Atherton
-
Could be your solenoid, see if you have 12 Volts when you try and start, also 12 volts direct from the battery.
-
Yes it sounds like the solenoid has jammed. Give it a whack with a hammer and that should free it off.
If you don't have a meter, short out the terminals on the solenoid and that will get the starter spinning if there is any power. ( Lots of sparks).
Good luck.
Pete.