SLROC Forum

looking to convert v8 auto to
manaul
so looking for bell houseing and flywheel

any one got any theses parts thankyou
regards
mike

anyone please

I have an R380 manual box with bellhousing and transfer box that came off a P reg 3.9 V8 if thats any use to you 

Bear in mind the crank in an auto engine has different thrust bearings compared to a manual engine.

Ignore what I said above, it only applies if going manual to auto 

R380's and LT77's have different bellhousings as do LT85s (applicable if buying parts individually.

So its a question of which box do you have ?

its going on to a 3.9

i have used the rangerover boxes before
only changing belhousins?
mike

ive got a flywheel, not pretty but would do the job

Bear in mind the crank in an auto engine has different thrust bearings compared to a manual engine.

Ignore what I said above, it only applies if going manual to auto 

You must fit a spiggot bush when converting from auto manual otherwise you run the risk of the gearbox inputshaft friction welding itself to the crankshaft....... NOT GOOD!

yep bob
i know as i said used to convert petrols to deisels
believe it or not the first 1 i done from auto petrol to manaul deisel
spigot bush from appleyards at hte time
cost me 40 quid
cause i never new what it was at the time
then after that it was brass bush turned down to suit
cost zero
leson learned
regards
mike
ps dont know if this 1 is going ahead now
think the lad has a change of mind