SLROC Forum

I'm after two items:

1) An 88" knife-edge bonnet. Preferably one with good front & rear frames, but has been damaged around the center of the bonnet.
I need to make a "power bulge" to fit over the top of an engine in a CCV vehicle
(I have a bonnet that's in A1 condition, and it would be a shame to butcher it )

2) An autobox from a 200tdi Discovery or Range Rover.
I need the full autobox, with torque converter and crankshaft drive-plate
I have an autobox from a 300tdi, but the bell-housing is (very) different, and there's a LOT of effort in making things fit :sadness:

Ian put a 300tdi bellhousing on the 200tdi engine?

Ian put a 300tdi bellhousing on the 200tdi engine?

No - the 200tdi has the crank-shaft oil-seal in the flywheel-housing - and the whole housing setup is different.
I may be lucky and be able to change the bellhousing itself - but the bolt-pattern for the autobox bell-housing to autobox is totally different to the R380 & LT77 gearboxes.

Got a dead 200tdi auto I can try? ;-)
(I still need the 200tdi drive-plate, mind....)

Ian, I've several bonnets in the shed, I'll have a look.

Gene.

Ian, I've several bonnets in the shed, I'll have a look.

Ace.... A nice scaffy, beaten-up bonnet... with pealing paint and mangled holes where someones ripped out the spare-wheel holder would be just grand

This do ?

This do ?

Lovely..... pm me a price, and I'll work out transport ;-)

Got a full 300tdi engine and auto box for sale still in car if any good

Got a full 300tdi engine and auto box for sale still in car if any good

'Fraid not..... I want to keep with the 200tdi as that's what I've got in my Discovery - means 1 set of consumables does both my Land Rovers, plus a couple of my mates cars too...