SLROC Forum
General Category => TECHNICAL CHAT => Topic started by: DRH on October 22, 2017, 09:18:25 PM
-
Disco 2 ABS Problem
After having a D2 in bits, it's nearing the end of a rebuild that involved stripping a lot of stuff off to get access to the front end/bulkhead area for welding etc.
The abs light is staying on and the Nanocom says there's no battery feed. If I clear the fault code, as soon as the ignition is switched back on, the fault and same code comes back. I've checked the fuses and swapped relays about but no luck. Does anyone have any ideal which colour wire is the feed at the modulator so I can check to see whether power is getting up to it?
Before it was stripped down it was a non runner and the abs light was on once it was up and running, but the only fault the Nanocom reported was a faulty wheel sensor.
Any pointers would be appreciated
Duncan
-
Hi, Txt sent
Trev