Register



Pages: [1]

Heating

· 6 · 1925
« previous next »

0 Members and 1 Guest are viewing this topic.

*

frankmac

  • *
  • Posts: 26
Heating
« on: September 07, 2010, 10:58:07 AM »
Hi Folks,

2.5 DSE Rangerover on a S plate,Blower speed working fine ,Temp not as warm as it should be ,on the control display showing some kind of warning symbol,anybody got idea where I should be looking to put right?

                                    Cheers......
Logged
*

MudBucket

  • *****
  • Posts: 266
Re: Heating
« Reply #1 on: September 07, 2010, 12:58:22 PM »
Hi,

is there enough water in the engine cooling system?
Logged
*

mac

  • *****
  • Posts: 171
Re: Heating
« Reply #2 on: September 07, 2010, 04:07:18 PM »
I assume you mean the display of the heater system rather than the dash display.  Presumably it's the book symbol?  As long as you have correct engine temperature and sufficient coolant/no airlocks and no leaks from the heater matrix the most likely problem is with the blend motors (or servo's).  Common problem on the P38 and is a 'dash out' job to sort  :-\
Logged
*

frankmac

  • *
  • Posts: 26
Re: Heating
« Reply #3 on: September 08, 2010, 08:51:12 AM »
Cheers Guys,

Checked the coolant ,no visable leaks....................
Logged
*

rangerovering

  • *******
  • Posts: 1272
Re: Heating
« Reply #4 on: September 08, 2010, 10:32:12 PM »
Could still have an air lock. The fool proof way to fill the coolant on P38's is with a vac pump. It sucks all the air out the system creating a vacuum then draws the coolant in.
Logged
Steve



*

frankmac

  • *
  • Posts: 26
Re: Heating
« Reply #5 on: September 10, 2010, 12:24:15 PM »
Cheers all,
will get stuck in over the week-end
Logged
Pages: [1]
« previous next »